When the value inside the register changes it is highlighted in red. Just make sure, you save the source code every time you make any changes to that. Leave a Reply Cancel reply. The EW Workspace Window looks something like this. However we do encourage you to try them out as well. You can download it from here. After configuring all the options.
|Date Added:||11 August 2014|
|File Size:||37.81 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Generally, the workspace area is in collapsed or compact or aggregated form by frree, but in the figure I have expanded the tree. This is required for us to step through and control the execution of the code.
Using IAR Embedded Workbench with MSP » maxEmbedded
If it says, communication error, it means that your Rx and Tx pins are not connected. Feel free to share your thoughts down below! In case of any questions, you can use the discussion panel below this post. The window containing the workspace and the editor space will appear. Just make sure, you save the source code every time you workebnch any changes to that. Anonymous not verified 18 June – However, when I am trying to debug the code on the device by using the USB debugger interface, I get the following error:.
It will initialize your device and check the connections first.
Trust me, it helps! If you absolutely need to share your code with us, use pastebin. A dialog box will appear.
Using IAR Embedded Workbench with MSP430
Comments Anonymous not verified 6 June – 8: You can also debug using step-into, step-over, and step-out buttons, but they are useless for this example. Discussion on this topic is out of scope of this iaf.
Installation Installation is simple, you can download the. Failed to re-initialize Session aborted! Just answer all questions and give your correct email isr. Well, up until now, we were merely glowing the two LEDs. It is limited to a program size of 4KB. They are useful for playing around when you have several function calls in your program.
All trademarks and service marks are the properties of their respective owners. Both of them are in active high configuration. What would happen if it stops working after you have driven workbebch couple of miles?
However, when Emberded am trying to debug the code on the device by using the USB debugger interface, I get the following error: You want your application to run forever until the system is rebooted, or some interrupt occurs. Now that we have our source code ready and compiled, the next step is to make the code. To add to these, you will also learn how to debug your code using the simulator and FET flash emulation tool debugger.
The view registers option is available in the debug mode only. We will write the code in C language, hence expand C and click on main. Upon compiling, you should get an error as shown in the figure below.
So give enough delay to see it blink. You can also see the LED connected to P1. You can see embeddd access the source code usually.
Modify the code to the following and repeat all the steps. Thank you for your cooperation.